Page 1 of 1

Good video on float setting

PostPosted: Mon Jun 01, 2015 11:02 am
Author: Jake
Hey guys,

I was doing a bit of YouTube surfing and came upon a series of videos.

This one is about float setting. How to adjust the Float Height on a Carburetor Metric harley and Asian

There are others, I urge you to check out some of them.

Re: Good video on float setting

PostPosted: Mon Jun 01, 2015 1:47 pm
Author: old rider
Good Video Thanks Jake

Re: Good video on float setting

PostPosted: Mon Jun 01, 2015 3:47 pm
Author: faffi
Thanks for sharing! Although I've adjusted the odd carb for decades, there are always hints to pick up.

Excelent link on how to adjust a carburetor float

PostPosted: Sat Jun 20, 2015 11:07 am
Author: jtsil
Found this link I watch the video at least 6 times, with lots of attention in the float position, I open my single carburetor without remove it , took the float out, complete crooked, nice for a just overhauled carburetor,
I reset everything as this mechanic teacher show, put everything back together and voila' it work it is screening, I am trying to start at different times, like five minutes stop, 15 minutes stop and 60 minutes stop, and it start at the first try, I want to know if will start tomorrow morning but so far so good.

Link bellow so if someone need some lessons in carburetor float.


https://www.youtube.com/watch?v=Xj220oY26Yo

Re: Good video on float setting

PostPosted: Sat Jun 20, 2015 3:02 pm
Author: faffi
Isn't that the very same link that the OP put up?

Re: Good video on float setting

PostPosted: Sat Jun 20, 2015 4:17 pm
Author: Jake
Yes, she started a new thread in XV700, I merged it to this one.

Re: Good video on float setting

PostPosted: Sat Jun 20, 2015 4:33 pm
Author: jtsil
Sorry guys I didn't notice the first post.