Page 1 of 1

Clutch replacement (SOLVED)

PostPosted: Fri Feb 15, 2013 2:19 pm
Author: Streetmedik
I found this article on clutch replacement.. they use a XV750 as the example. Complete with photos.
http://www.motorcyclecruiser.com/tech/c ... placement/

Re: Clutch replacement

PostPosted: Sat Feb 16, 2013 10:38 am
Author: mark75
Here's my "VTF CliffsNote" version.
viewtopic.php?f=4&t=7482

Re: Clutch replacement

PostPosted: Sat Feb 16, 2013 11:06 am
Author: Jake
mark75 wrote:Here's my "VTF CliffsNote" version.
viewtopic.php?f=4&t=7482

Moved your "VTF CliffsNote" to "Tech Articles"

Re: Clutch replacement

PostPosted: Mon Apr 08, 2013 3:11 am
Author: mark75
Thanks Jake.

@ apvkt.
I deleted your post about replacing an automobile clutch.
It was not well served on this forum/thread.
check your PM.

Re: Clutch replacement

PostPosted: Tue Apr 08, 2014 3:37 pm
Author: --weezl--
the first link's photos have been removed :(

just to be clear with the first link, he said lean it over so the oil doesn't leak out, does this mean that you can actually do this with a crankcase full of oil? :eek:

and to be sure, because i don't think it said anywhere plainly, the parts you will need if your clutch is worn beyond repair, is a set of steel plates, a set of organic plates (kevlar, composite ect) springs, and gaskets, that's it?

Re: Clutch replacement

PostPosted: Tue Apr 08, 2014 4:38 pm
Author: Dave-the-rave
I'd replace the screws as they can break easy, and a new lock washer.

Re: Clutch replacement

PostPosted: Wed Aug 13, 2014 11:46 pm
Author: grnrngr
+1!! Even tho they only get torqued to like 5ft/lbs, three of mine broke last time I did my clutch. Just ordered a new set myself, rebuilding my clutch next week.

Clutch replacement SOLVED

PostPosted: Thu Dec 11, 2014 3:44 pm
Author: R19mi
in my opiion when it gets harder to pull replace the clutch cable most are easy to change out

Re: Clutch replacement (SOLVED)

PostPosted: Thu Dec 11, 2014 6:49 pm
Author: mark75
ditto:
cable [hiding in plain site] is easily over-looked. it should be visually inspected [both ends] and lubed [I use motor oil] before re-installing - if not replaced.